|
Basic passives in place.
Note: chip caps C17 and C18 (circled) are the thick ones.
Date: 06/04/2008
Views: 7684
|
Another shot of C17 and C18, they just sit next to each other and get soldered down.
Date: 06/04/2008
Views: 5178
|
T1 starts out like this.
Date: 06/04/2008
Views: 5577
|
|
Trim and strip the leads, but don't tin them or they may not fit through the holes in the PCB (or just tin the very ends lightly
Date: 06/04/2008
Views: 221953
|
Now tack down this side, you have better access to this side...
Date: 06/04/2008
Views: 5791
|
Now solder down this side, and then go back and completely solder the other side that you tacked down before.
Date: 06/04/2008
Views: 4031
|
|
Now feed the leads through the PCB with needle nose pliers, and solder them down.
Date: 06/04/2008
Views: 3110
|
T3 starts out like this.
Date: 06/04/2008
Views: 3856
|
Just like T1, trim and very lightly tin the leads.
Date: 06/04/2008
Views: 5216
|
